Download  Print this page

Troubleshooting; What To Do If - Westinghouse WDF901 User Manual

Hide thumbs

Advertisement

14 westinghouse

What to do if...

The appliance does not start or stops during
operation.
If there is a fault, first try to find a solution to
the problem yourself. Refer to 'What to do
Fault code and malfunction
• The running program light contin-
ues to flash
• The READY indicator light flashes
once
The appliance does not fill with water
• The running program light contin-
ues to flash
• The READY indicator light flashes
twice
The appliance does not drain
The program does not start
After the check, switch on the appliance. The
program continues from the point of inter-
ruption. If the malfunction shows again, con-
tact your Customer Care Centre.
These data are necessary to help you quickly
and correctly:
• Model (Mod.)
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots
or a bluish coating on glasses
and dishes
Dry water drop signs on
glasses and dishes
• The water tap is blocked or restricted with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The installation of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The installation of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected.
Plug-in appliance to the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the program immediately.
The cleaning results are not satisfactory
• The selected washing program is not applicable for the type of load
and soil.
• The baskets are loaded incorrectly so that water cannot reach all
surfaces.
• Spray arms do not turn freely because of incorrect arrangement of
the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
• No rinse aid has been used.
• The rinse aid dispenser is empty.
• Decrease the rinse aid dosage.
• Increase rinse aid dosage.
• The detergent can be the cause.
if...'. If you cannot find a solution to the prob-
lem yourself, contact your dealer or the Cus-
tomer Care Centre.
Possible cause and solution
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........

Hide quick links:

Advertisement

Table of Contents
loading