Table of Contents
Advertisement
MAINTENANCE AND CLEANING
Spray arms
Check whether the holes for the upper and lower spray
arms are clogged . If there is any clogging, remove the
spray arms and clean them under water .
You can remove the lower spray arm by pulling it
upwards, while the upper spray arm can be removed
by turning the lock nut to the left . Be sure that the nut is
tightened when refitting the upper spray arm .
Hose filter
The inlet hose filter reduces contamination (sand, clay,
rust etc .) that might be occasionally carried in through
the main's water supply or the indoor plumbing, and
avoids damage to dishwasher components . Check the
filter and the hose from time to time and clean them if
necessary . To clean the filter, first turn off your tap and
then remove the hose . After removing the filter from the
hose, clean it under the tap . Insert the cleaned filter back
into its place inside the hose . Refit the hose and check
that there are no leaks .
22
MAINTENANCE AND CLEANING
FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE
ERROR CODE
ERROR DESCRIPTION
F1
Leak detection
F2
Draining fault
F3
Water overfill
F5
Water supply fault
F6
Faulty heater sensor
F7
Overheating (water temperature too high)
F8
Not heating
F9
Flow control position error
FE
Power supply fault
H01 – H24
Delay has been selected
PRACTICAL AND USEFUL INFORMATION
1
Whenever you will not be operating your machine:
•
Unplug the machine and then turn the water off .
•
Leave the door slightly ajar in order to prevent
the formation of unpleasant odours .
•
Keep the machine interior clean .
2
Eliminating water droplets:
•
Wash the dishes with the intensive program .
•
Increase the rinse aid setting .
•
If plastic items are washed, water drops on these
items will be unavoidable . Programs with higher
temperatures and increased rinse aid settings
may reduce the water drops . Check that the
plastic items are suitable for dishwasher use .
3
Correctly loaded dishes will give the best energy
consumption, washing and drying performance .
CONTROL
• Switch off the dishwasher and close the tap
• Contact the service centre .
• Cancel program and power off machine, then check the following
• Spigot on sink trap is clogged
• Check if the drain spigot membrane has been removed
• Drain hose is clogged
• Filters of the dishwasher may be clogged
• If error continues contact the service centre .
• Close the tap
• Contact the service centre .
• Make sure the water tap is open and the main water supply is on
• Close the tap, disconnect the hose and clean the filter at the tap
connection end
• Check the inlet hose is not kinked
• If error continues contact the service centre .
• Contact the service centre .
• Contact the service centre .
• Contact the service centre .
• Contact the service centre .
• Restart the dishwasher .
• Cancel the delay setting .
4 Scrape off food soils before you place dirty dishes
in the machine .
5
Operate the machine after it is completely full .
6 Use pre-washing program only when necessary .
7
Observe program information and average
consumption values table when selecting a
program .
8
Since the machine will reach high temperatures,
it should not be installed near a refrigerator .
9 If the appliance is located where the risk of freezing
exists, you must completely drain the water that
has remained in the machine . Turn off the water tap,
disconnect the water inlet hose from the tap and
allow the interior water to drain .
MAINTENANCE AND CLEANING
MAINTENANCE
23
Hide quick links:
Advertisement
Table of Contents
