Troubleshooting; What To Do If - Westinghouse WSF6605 User Manual

FROST PRECAUTIONS
Caution! Do not install the appliance
where the temperature is below 0 °C.
The manufacturer is not responsible for
damage caused by frost.
MOVING THE APPLIANCE
1. Disconnect the mains plug from the
mains socket.

WHAT TO DO IF...

The appliance does not start or stops dur-
ing operation.
If there is a fault, first try to find a solution to
the problem yourself. Refer to following
charts. If you cannot find a solution to the
problem, contact your dealer or the Cus-
tomer Care Centre.
With some malfunctions, the display
shows an alarm code:
Malfunction
The appliance does
not fill with water
The appliance does
not drain the water
The anti-flood device
operates
The program does
not start
Possible cause
The water tap is closed.
The filter in the water inlet hose is
blocked.
The installation of the water inlet
hose is not correct. The hose is bent
or squashed.
The water tap is blocked or restric-
ted with limescale.
The water pressure is too low.
There is a blockage in the sink spi-
got.
The installation of the water drain
hose is not correct. The hose is bent
or squashed.
The appliance door is not closed.
The START button has not been
pressed.
Mains plug is not connected.
The delay start is set.
The fuse has blown out in the
household fuse box
2. Close the water tap.
3. Remove the appliance and the hoses.
4. Do not tilt the appliance during trans-
port.
•
- The appliance does not fill with wa-
ter
•
- The appliance does not drain the
water
•
- The anti-flood device operates.
Warning! Switch the appliance off
before you do the suggested corrective
actions.
Possible solution
Open the water tap.
Clean the filter.
Make sure that the installation is cor-
rect.
Clean the water tap.
Contact your local water authority.
Clean the sink spigot.
Make sure that the installation is cor-
rect.
Close the water tap and contact
your Customer Care Centre.
Close the door.
Press the START button.
Plug-in the appliance to the mains.
• Cancel the delay start.
• Wait until the countdown of the
delay start is completed.
Replace the fuse.
westinghouse 15