Electrical Connection; Fitting The Machine Undercounter - Westinghouse WSF6606 User Manual

INSTALLING THE MACHINE
Water drain hose
Floor level
This connection should be at a minimum of 50 cm and at
a maximum of 110 cm above the base of the dishwasher .
WARNING
WARNING
Maximum drain hose length
is 4m . Longer hose length will prevent correct draining,
and result in poor wash performance .
Timber
wedging
1
piece
Bench top
The water drain hose can be
connected either directly to
the water drain hole or to the
sink outlet spigot . Using a
hose hook (if available), the
water can be drained directly
into the sink by positioning
the hose hook over the edge
of the sink .
Filler piece
2
cut to suit
installation
3mm gap
WARNING
WARNING

Electrical Connection

The plug of your machine should be connected to an earthed
outlet that supplies suitable voltage and current . If there is no
earthing installation, have a competent electrician carry out
an earthing installation . In case of usage without earthing
installed, our company will not be responsible for any loss of
usage that might occur .
The indoor fuse current value should be 10-16 A .
Your machine is designed for 220-240 V . The machine
should not be plugged in during installation .
• Always use the molded plug supplied with your machine .
• Running in low voltage will cause a decline in
washing quality .
• The machine's electrical cable should be replaced by
an authorised service or an authorised electrician only .
Failure to do so may lead to accidents .
• For safety purposes, always make sure to disconnect the
plug when a wash program is finished .
• In order not to cause an electric shock, do not unplug
when your hands are wet .
• When disconnecting your machine from the mains supply,
always pull from the plug . Never pull the cord itself .

Fitting the machine undercounter

If you wish to fit your machine undercounter, check whether
you have sufficient space under your countertop and whether
the wiring-plumbing is suitable to do so .
1 To ensure the stability of the dishwasher for an
underbench installation, if the underbench dimension is
greater than 820mm, any gap between the dishwasher
and the underside of the benchtop should be bridged
with a packing piece . This may be achieved by wedging
a piece of timber between the dishwasher and the
benchtop as shown
2 If required, remove the worktop as shown in the
illustration .
3 To remove the worktop, remove the screws that hold the
worktop which are located at the rear of the machine;
then push the front panel 1 cm from the front towards
the rear and lift it .
596
598
3
INSTALLING THE MACHINE
INSTALLATION
9