Table of Contents
Advertisement
7.1 Virtual Outputs
Addressing in the case of JC-647 controllers equipped with JX6-
SB(-I), or DELTA controllers with JX6-SB(-I):
Output number: m
Meaning:
For more information, for example on register overlaying of outputs, refer to the
User's Manual that comes with the JX6-SB(-I) module.
Addressing in the case of JC-800 controllers equipped with JX6-
SB(-I):
The IO address starts with the area number 5.
Meaning:
For more information, for example on register overlaying of outputs, refer to the
User's Manual supplied with the JC-800 controller.
50
xxzz
1
m
x
x
z
1
Output number:
53CM xxzz
5
2..3
C
M
Note!
To determine the module number, the digital input or output modules are
counted. Intelligent modules, such as JX2-SV1, JX2-SM2, JX2-PID1 modules,
etc., located among the digital input and output modules, are not taken into
consideration.
Module # 1 is assigned to the basic controller. Starting from there, the module
numbers are counted left to right.
Basically, the granularity is 16. That means, for example, that 16 outputs are
allocated to the JX2-CNT1 module, irrespective of the fact that only 8 virtual
outputs can be addressed.
z
I/O number: 01...08
I/O module number: 02...32
Submodule socket + 1: 2...4
x
x
z
z
I/O number: 01...08
Module number JX2-I/O: 02...32
System bus module: 1...2
Module board number: 1...3
2: Input
3: Output
Area: 5
JetWeb
Jetter AG
Advertisement
Table of Contents
