Basic Settings
1.2 Network
With the Basic Settings:Network dialog you define the source from
which the device gets its IP parameters after starting, and you assign the IP
parameters and configure the HiDiscovery access.
Figure 9: Network parameters dialog
Under "Mode", you enter where the device gets its IP parameters:
In the BOOTP mode, the configuration is via a BOOTP or DHCP
server on the basis of the MAC address of the device
„Saving the configuration").
In the DHCP mode, the configuration is via a DHCP server on the
basis of the MAC address or the name of the device
„Saving the configuration").
In the local mode the net parameters in the device memory are used.
Enter the parameters on the right according to the selected mode.
You enter the name applicable to the DHCP protocol in the "Name" line in
the system dialog of the Web-based interface.
RM Web L2B
Release 5.0 04/09
1.2 Network
(see on page
28
(see on page
28
21