How To Communicate With The Viewing Unit - TEXA Nagivator Nano Technical Manual

10.4 How to Communicate with the Viewing Unit

The tool is not equipped with a user interface and the data
acquired is sent to an appropriate viewing unit.
Before starting the communication with the display
unit, you must perform the special configuration
procedure.
The connection of the tool to the display unit can occurr in the
following modes:
Bluetooth
•
• USB
To best exploit the potential of the tool, you must use the
Bluetooth connection.
Power, connect and turn on the tool before starting
up the programs which will be used to interface with it. If
this procedure is not followed communication errors
could occur.
While the tool is turning on it automatically detects the
communication mode through which it is connected to the
display unit.
For example: the Bluetooth communication mode (active by
default) is disabled when the USB cable is connected.
To change the communication mode between the
tool and the viewing unit you must first turn off the tool
and then choose the mode you prefer.
en
41