Power Ssupply Through Lighter Cable - TEXA Nagivator Nano Technical Manual

en

10.2.3 Power Ssupply Through Lighter Cable

The device may also be powered by the battery⌐ of the
vehicle being tested, thanks to an appropriate cable which
can be connected to the car adapter via a jack.
The connection through the lighter socket (if available) is
possible only by using an appropriate cable.
1. Device
2. Car adapter
3. Connection cable for the cigarette lighter socket
Proceed as follows:
1. Connect the device to the adapter.
2. Connect the connection cable for the cigarette lighter socket to the
adapter.
3. Connect the cable to the cigarette lighter socket.
The green LED remains on (does not flash) if the device is
being powered properly.
In this case the green LED on the connector for the lighter
socket will also turn on.
If using the cigarette lighter socket within the
vehicle make sure power is continuously being supplied
(therefore not just with the ignition key on the ON
39