Connecting To The Control Unit - TEXA Nagivator Nano Technical Manual

10.6 Connecting to the Control unit

To carry out self-diagnosis you are required to connect the
tool to the diagnosis socket of the vehicle and activate the
connection between the tool and control unit via the software.
Proceed as follows:
1. Via the software select the vehicle and the system on which you
wish to carry out the self-diagnosis.
2. Locate the diagnostic socket using the information (images or
short video) provided by the software.
3. Connect the tool to the control unit using, when required, the
appropriate cables and adapters indicated by the software. .
A flashing green LED indicates that the vehicle control unit
and the device are communicating correctly.
The position and the type of the socket on the vehicles vary
according to the make and model; this is why the software
provides the information required to locate it.
en
45