Test Case 6 - Simulate Link P2 Failure On Srx; Test Case 7 - Simulate Link P1 Failure On Vsp With The Cli - Avaya VSP 7000 Technical Configuration Manual

5.6 Test Case 6 – Simulate Link p2 Failure on SRX
The objective of this test case is to simulate Link p2 failure on the Coraid SRX while sending traffic and
then validate that data continues to run on the remaining link.
Test Steps
1) Restart Vdbench with both links
on the HBA and two links per
SRX.
2) After Vdbench has been running
for a few minutes, remove link
number p2 on the SRX.
3) Wait for Vdbench to finish reading
and writing to verify the results.
5.7 Test Case 7 – Simulate Link p1 Failure on VSP
with the CLI
The objective of this test case is to simulate Link p1 failure on the Avaya VSP 7000 with the CLI while
sending traffic. Then validate that data continues to run on the remaining link.
Test Steps
1) Confirm that all links are up on the
VSP.
Start Vdbench from the PCs.
2) After Vdbench has been running
for a few minutes, disable Link p1
on all PCs using the VSP CLI.
3) On each PC, confirm that Vdbench
continues reading and writing to
the storage array.
4) Wait for Vdbench to finish reading
and writing to verify the results.
August 2011
Expected Results
Vdbench should launch and begin
reading and writing to the storage
array.
Vdbench should continue to read and
write to the storage array.
Vdbench should finish with no errors
in the log file and all data should be
validated.
Expected Results
Vdbench should launch and begin
reading and writing to the storage
array.
Transfer rate will be affected since
one port will be removed, but I/O
should continue.
Confirm that Vdbench continues to
read and write to the storage array
with half the links available.
Vdbench should finish with no errors
in the log file and all data should be
validated.
Avaya VSP 7000 with Coraid EtherDrive SRX-Series
Storage Appliances TCG
avaya.com
Actual Results
Pass
Pass
Pass
Actual Results
Pass
Pass
Pass
Pass
19