JVC DLA-VS4010 Instructions Manual page 58

C
Filter Cover
Remove the filter cover
1
The filter is located at the front side of the projector unit.
Remove the sponge and filter
2
Hold the center of the filter using your fingers, and pull the filter toward you to remove it.
Clean the sponge and filter
3
Remove any dirt or dust using a vacuum cleaner.
CAUTION
Do not clean using a flammable air duster. This may cause fire.
0
Mount the sponge and filter
4
Mount the filter and sponge to the projector using the reverse removed procedure.
Finally, check to ensure that the filter cover is firmly mounted.
MEMO
Mount the filter correctly. Failure to do so may cause the projector to malfunction.
0
The projector may stop operating if a damaged filter or filter panel is used. In this case, replace the filter or filter panel
0
with a new one.
58
Filter
Filter Cover
Sponge
CAUTION
Remove the four screws on
0
the inner side (for fastening
the filter cover).