Danfoss VLT 5000 Operating Instructions Manual page 34

No. Parameter
753 Endless positioning
ENDLESS POS.
776 Factory reset
FACTORY RESET
777 Parameter save
STORE DATA
778 Password
PASSWORD
779 Software version
VERSION 2.10
795 Actual position
ACTUAL
POSITION
796 Actual inputs
ACTUAL INPUTS
797 PID tracking error
PID TRACK
ERROR
MG.50.P3.02 - VLT is a registered Danfoss trademark
Positioning Controller
Default Range
value
0 0 ... 1
0 0 = disabled
1 = enabled
0 0 = no action
1 = SAVE
EEPROM
1,234 0 ... 999,999,999
210 210
0 –2,000,000,000 ...
2,000,000,000 UU
00000000 00.00.00.00 /
11.11.11.11
0 –2,000,000,000 ...
2,000,000,000 UU
Description
Set this parameter to "1" if drive must per-
form positioning continuously in one direc-
tion. Remember to also set parameter 751,
752 and 736 to "0".
By setting this parameter to "1" it is
possible to reset all parameter values to
default. This also resets all trajectory data
(P739-P743).
The parameter automatically resets to "0"
when the reset is successfully carried out.
Parameter and trajectory data is not auto-
matically stored in EEPROM and will thus
not automatically be available after power-
down and power-up.
To permanently store changes made to
parameter values and/or trajectory data
parameter P777 must be set to "1". This
parameter automatically resets to "0" when
the data is successfully stored.
Not used.
The text in this parameter shows the
current version number of the Positioning
Controller program.
READ-ONLY PARAMETER:
This parameter displays the latest position
obtained from the feedback encoder.
READ-ONLY PARAMETER:
This parameter displays the last read
status of the digital input on the option card
(MK3A). The status of the digital inputs on
the VLT5000 control card is accessible via
P528
READ-ONLY PARAMETER:
The current PID tracking error is displayed
in this parameter in user units.
33