•
Physical Drive ID – ID number of the physical drive
•
Location – Enclosure number and slot number
•
Alias – If assigned
•
Physical Capacity – Total capacity in GB
•
Configurable Capacity – Usable capacity in GB
•
Used Capacity – Capacity actually used in GB
•
Block Size – Typically 512 Bytes
•
Operational Status – OK is normal, Stale, PFA, Dead
•
Configuration Status – Array number and sequence number, spare
number
•
Model Number – Make and model of the drive
•
Drive Interface – SATA 1.5Gb/s or 3Gb/s
•
Serial Number – Serial number of the drive
•
Firmware Version – Firmware version on the drive
•
Protocol Version – ATA/ATAPI protocol version
3.
Click the Advanced Information tab.
Advanced information for physical drives includes:
•
Write Cache – Enabled or disabled *
•
Read Look Ahead Cache – Enabled or disabled *
•
SMART Feature Set – Yes or No
•
SMART Self Test – Yes or No
•
SMART Error Logging – Yes or No
•
Command Queuing Support – TCQ or NCQ
•
Command Queuing – Enabled or disabled *
•
Queue Depth – Number of commands
•
Maximum Ultra DMA Mode Supported
•
DMA Mode
•
Power Saving Level – Supported by this drive
•
Medium Error Threshold **
Items with an asterisk (*) are adjustable under "Viewing Physical Drive
Statistics" on page 40.
Items with two asterisks (**) are adjustable under "Making PDM Settings" on
page 36.
4.
Click the X icon to close the information panel.
Chapter 3: Management with the Promise Utility
39