GSSI StructureScan Mini XT Quick Start Manual page 15

StructureScan Mini XT Quick Start Guide
2
Back the Mini XT up in a straight line. You will see a yellow vertical line (the backup cursor) appear on the screen.
The position of this cursor is tied to the Mini XT's survey wheel. Stop when the cursor bisects a hyperbola.
3
Mark the survey surface at both side laser points, and then back the Mini XT up a little further and make an "X" in the
middle between those laser marks. Note that objects you are imaging run perpendicular to the track of the Mini XT.
After each line, select New File to collect a new line.
Page 11