Enable Interface; Enable Ip Ospf - Zte ZXR10 8900 Series Command Reference Manual

All manuals and user guides at all-guides.com
disable area
Related
Commands

enable interface

Use this command to enable the disabled interfaces in the specified
Purpose
range. It is ineffective for the enabled interfaces.
Router configuration
Command Modes
enable interface <ip-address><wildcard-mask>
Syntax
Syntax
Description
<ip-address>
<wildcard-mask>
If this area has been configured, it is valid by default.
Defaults
This command is supported after the platform version 4.6.02.
Instructions
This example enables interface addresses of the network 10.1.0.0.
Example
ZXR10(config)#router ospf 1
ZXR10(config-router)#enable interface 10.1.0.0 0.0.255.255
disable interface
Related
Commands

enable ip ospf

Use this command to enable the OSPF protocol if it is disabled.
Purpose
Otherwise, the command is ineffective.
Global configuration
Command Modes
enable ip ospf <process-id>
Syntax
Syntax
Description
<process-id>
If the OSPF protocol has been configured, it is enabled by default.
Defaults
This command is supported after the platform version 4.6.02.
Instructions
This example enables OSPF process 1.
Example
ZXR10(config)#enable ip ospf 1
IP address, in the form of dotted decimal
Wildcard mask, in the form of dotted decimal
OSPF process ID, namely, the configured
OSPF instance number, range: 1~65535
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 OSPF Protocol
51