Uhf pll single/dual channel diversity system (23 pages)
Summary of Contents for JTS IN264R
Page 1
UHF PLL Dual Channel Diversity Wireless System * The system is of the innovative design to allow changing the transmitter’s frequency by long-distance . * IN264R with band width of 36 MHz. * Preset 6 groups, maximum 23 channels in one group. 59508-021-02...
The SAM-8W 5-3 Synchronize the channel delivers vivid details of vocal and instruments. 5-4 Check system status The IN264 is of stylish industry design. Yet JTS bombproof quality remains as always. 5-5 Manual select channel 5-6 REMOSET button lock 5-7 Adjust the sensitivity of the microphone 6.
Life 3. Parts Identification LCD Panel of the Receiver AF Level: display the strength of audio signal 3-1 IN264R RF Level: display the strength of radio signal Front panel Antenna Status: the receiver will automatically select an antenna with stronger signal level...
Music INFINITY Life 3-3 IN264TB 4. Connection LCD Display 4-1 Connect to the subsequent unit (e.g. mixer, or amplifier) Battery Tray Connect one end of a proper AF cable to the AF Output or Balanced XLR Set button: set the configuration of bodypack transmitter Output socket , then plug another end to the “MIC IN”...
When ID code is off (idOFF), the transmitter will accept any After the transmitter's power is on, short pressing the "Power Switch " synchronization from any IN264R. will mute the microphone. Press the "Power Switch" again will re-activate ID code selecting the microphone.
Music INFINITY Life 5-5 Manual select channel: 5-3 Synchronize the channel Receiver A) Press "Set" button on the receiver for 3 Seconds, the group (G) in the "Group & Channel" area will flash. (Figure 4) A) Press "Set" button for 3 seconds, the group (G) in the "Group & Channel" area will flash.
Music INFINITY Life 5-6 Lock ON Function 5-7 Adjust the sensitivity of the microphone Receiver Handheld transmitter A) Press "Set" button for 3 seconds to enter A) Press "Set" button for 3 seconds to enter setting window B) Press "Set" again until the Lock setting window shows. (Figure 10) setting window.
“OFF” means “REMOSET” function is turned off 6-2 IN264TH When ID code is OFF (id OFF), the transmitter will ID code ON/OFF Frequency Preparation..PLL Synthesized Control accept any synchronization from any IN264R. Carrier Frequency Range..502~960 MHz RF Outputs......10mW Stability........