Table of Contents
Advertisement
MAINTENANCE PROCEDURES
smo2008-001-052_a
TYPICAL — ALL MODELS EXCEPT GTI
1. Fitting
Throttle Cable
Throttle Cable Inspection
Depress and release throttle lever
or finger throttle. It should operate
smoothly and return to its initial po-
sition without any hesitation. There
must be a small amount of free-play
when released. Refer to an authorized
Sea-Doo dealer if necessary.
NOTICE
Never attempt to adjust
the idle speed through the throttle
body tamper proof screw. If so, it
would impair the idle speed stabil-
ity. Besides, no adjustment could be
performed by the dealer nor the fac-
tory to correct the idle speed. The
throttle body would need to be re-
placed at the customer's expense.
Also take into account that might
change the engine emission level
and the engine might not meet the
EPA/CARB requirements.
WARNING
Do not alter or tamper with throttle
cable adjustment or routing.
WARNING
If throttle lever or f inger throttle
does not automatically return, do
not operate watercraft and see
your authorized Se a-Doo dealer.
______________
90
smo2008-001-009_b
X PACKAGE
1. Should move freely
2. Slight free-play must be present here
smo2008-001-008_b
OTHERS
1. Should move freely
2. Slight free-play must be present here
Throttle Cable Lubrication
Lubricate the throttle cable with XP-S
Lube or equivalent.
Fuses
Fuse Removal/Inspection
If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.
Use the fuse remover/installer in-
cluded in the fuse box to ease fuse
removal.
Advertisement
Table of Contents
