Table of Contents
Advertisement
MAINTENANCE PROCEDURES
Ride Plate and Water Intake
Grate
Ride Plate and Water Intake Grate
Inspection
Inspect ride plate and jet pump water
intake grate for damage. Have dam-
aged parts repaired.
WARNING
The DESS key should always be
removed from its post prior to in-
specting the intake grate.
TYPICAL — INSPECT THESE AREAS
1. Water intake
2. Ride plate
Ski/Wakeboard Post
(if so equipped)
Ski/Wakeboard Post Inspection
Check ski/wakeboard post operation.
Ensure it slides up and down easily.
Check locking mechanism operation.
Check fasteners tightness. If some-
thing is found defective, don't use
ski/wakeboard post and see an autho-
rized Sea-Doo dealer for repair.
______________
92
Ski/Wakeboard Post Lubrication
Lubricate ski/wakeboard post through
all its length. Pull out then push in sev-
eral times to distribute the lubricant.
Body and Hull
Body and Hull Cleaning
Occasionally, wash the body with wa-
ter and soap (only use mild detergent).
Remove any marine organisms from
engine and/or hull. Apply non- abrasive
wax such as silicone wax.
NOTICE
Never clean fiberglass
and plastic parts with strong deter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
Stains may be removed from seat and
fiberglass with Knight's Spray-Nine
from Korkay System Ltd or the equiva-
lent.
To clean the carpets, use 3M™ Citrus
Base Cleaner (24 oz spay can) or the
equivalent.
Respect the environment by ensuring
fuel, oil or cleaning solutions do not
drain into the waterways.
WARNING
Periodically verify seat(s) lock pin
and tighten if needed. Make sure
seat(s) securely latches.
Advertisement
Table of Contents
