Storage And Preseason Preparation; Storage - BRP GTX Series Operator's Manual

STORAGE AND PRESEASON PREPARATION

Storage

WARNING
Because fuel
flammable, have an authorized
Sea-Doo dealer inspect the fuel
system integrity as specified in the
periodic inspection chart.
It is recommended that the watercraft
be serviced by an authorized Sea-Doo
dealer for storage but the following op-
erations can be performed by you with
a minimum of tools.
NOTE: Carry out the following tasks in
the same order as detailed in this sec-
tion.
NOTICE
Do not run the engine dur-
ing the storage period.
Fuel System Protection
Sea-Doo fuel stabilizer (or equivalent),
should be added in fuel tank to pre-
vent fuel deterioration and fuel system
gumming. Follow stabilizer manufac-
turer's instructions for proper use.
NOTICE
Fuel stabilizer should be
added prior to engine lubrication
to ensure fuel system components
protection against varnish deposits.
and oil are
_______________
WARNING
Always stop the engine before re-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventilated
area. Do not smoke or allow open
flames or sparks in the vicinity.
Fuel tank may be pressurized, turn
cap slowly when opening. Never
use an open flame to check fuel
level. When fueling, keep water-
craft level. Do not overfill or top
off the fuel tank and leave water-
craft in the sun. As temperature
increases, fuel expands and might
overflow. Always wipe off any fuel
spillage from the watercraft. Pe-
riodically verify fuel system. Al-
ways turn the fuel tank valve (if so
equipped) to OFF position when
the watercraft is not in use.
Throttle Cable Lubrication
Lubricate throttle cable with XP-S
Lube.
Exhaust System Flushing
Perform procedure as described in
POST-OPERATION CARE
Engine Oil and Filter Replacement
The oil change and filter should be
performed by an authorized Sea-Doo
dealer.
Intercooler Protection
255 Models (X Packages)
It is important to expel any trapped wa-
ter that may have accumulated from
condensation in the intercooler.
Proceed as follows:
1. Removed the intake hose from the
throttle body.
.
93