Installing The Additional Microprocessor - IBM xSeries 225 8647 Installation Manual

10. If the configuration shown in the wizard is satisfactory, click Next to save the
11. Click Finish to complete the process.
12. Click Yes to restart the server.
13. Continue with step 1 of "Installing the additional microprocessor".

Installing the additional microprocessor

The following illustration shows how to install an additional microprocessor.
Complete the following steps to install an additional microprocessor:
configuration.
Microprocessor
baffle
Microprocessor 2
Heatsink 2
Captive screws
1. Review the safety information beginning on page v, "Installation guidelines" on
page 7, and "Handling static-sensitive devices" on page 8.
2. Turn off the server and all attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the side cover (see "Removing the side cover" on page 10).
5. Remove the support bracket ("Removing and installing the support bracket" on
page 12).
6. Remove the adapter airflow guide:
a. Rotate the front and rear adapter-retention brackets to the open (unlocked)
position.
b. Slide the adapter airflow guide out of the guides on the air baffle and front
adapter-support bracket; then, remove it from the chassis.
7. Remove the air baffle by unhooking it from its retaining tabs and lifting it off the
chassis.
8. Locate the second microprocessor socket (connector CPU2) on the system
board.
9. Remove the microprocessor baffle from the second microprocessor socket.
Microprocessor
release lever
DIMMs
Chapter 2. Installing options
31