IBM xSeries 225 8647 Installation Manual page 56

Complete the following steps to replace a hot-swap power supply:
1. Review the safety information beginning on page v and "Installation guidelines"
2. Press the orange release lever on the selected power supply; then, pull the
3. Make sure the power-supply handle is in the open position; then, slide the
4. If the server is not on, turn on the server.
5. Verify that the dc power LED and the ac power LED on the power supply are lit,
36
IBM xSeries 225 Type 8647: Option Installation Guide
on page 7.
power supply out of the bay and set it aside.
power supply all the way into the chassis before placing the power-supply
handle into the locked position.
indicating that the power supply is operating properly.