Setting Up The Microsoft Windows Operating System; Installing Applications And Drivers - Siemens SIMATIC Panel PC 677 Operating Instructions Manual

7.1.3

Setting up the Microsoft Windows operating system

Introduction
The setup wizard appears immediately following the startup of the device. The wizard is
used to set the parameters of the operating system.
Note
The dialogs of the setup wizards differ slightly in some places for the Windows 2000 and
Windows XP operating systems.
In order to change to the next dialog, click on the ">>" button. In order to change the entry in
the previous dialog, click on the "<<" button.
Procedure
1. Accept the Microsoft licensing agreement.
2. Leave the regional settings of the operating system unchanged. If required, adjust the
3. Enter the company names and user names.
4. If his PC name is already in use as you attempt to connect the device to a network: Enter
The system settings are updated. The desktop is set up. The setup of the operating system
is complete.
7.1.4

Installing applications and drivers

Introduction
After the device is restarted, different dialogs appear on the screen. Drivers and applications
can be installed from these dialogs.
Additional hardware and software components
You can install and configure additional hardware and software components such as a
network. For additional information, refer to the documentation of the hardware and software.
Note
The directory "c:\i386" contains special Windows components for subsequent installation.
SIMATIC PC Panel PC 677/877, Control Unit
Operating Instructions, Edition 04/2005, A5E00407724-01
regional settings of the operating system only after commissioning.
a new PC name for identification.
The operating system will restart automatically.
Operating and parametrizing
7.1 Startup
7-3