Lantronix xPico Quick Start Manual page 8

5. Enter the IP address.
The Subnet mask appears automatically based on the IP address.
You may change it. On a local network, you can leave the Default gateway
blank (all zeros).
6. Click Next.
7. Click Assign and wait several seconds until a confirmation message
appears.
8. Click Finish.
9. Select the xPico from the main window list and click ToolsPing. The
results appear in the Status area.
10. Click Clear Status to clear the window to ping the device again.
Note:
If you do not receive "Reply" messages, ensure the IP address assigned is
valid for the particular network segment you are working with.
11. Click Close.
xPico Development Kit Quick Start Guide
8