Electrical connection
Connect the power supply cable into the IEC connector (5).
•
Before connecting the device, check that the mains voltage matches the marking plate (8) (100-120V~
or 220-240V~ 50-60Hz) on the side of the device.
•
Only use the original cable supplied with the device.
•
To avoid a risk of electric shock, the device must only be connected to a power supply network
equipped with a protective earth.
Manual
1. Press the ON/OFF switch (7).
The display illuminates, the Manosplint® dry heat oven performs a self-diagnosis.
2. Set the desired target temperature by pressing keys
the temperature degree by degree.
7
(12) to increase the temperature or
12
13
EN
(13) to decrease
5/12