Triax 492055 User Manual page 28

TDX Service Tool
Rev. 01 - 2014 - E
891076E_492055_492056_TDX_QAM_module - User Guide - EN.indd 28
If you prefer not to use a barker channel you have the following options:
Full Actual - Full Other
Full Actual - P/F Other
Full Actual - No Other
P/F Actual - P/F Other
P/F Actual - No Other
No Actual - No Other
Manual transport
stream ID
Use static NIT
version
NIT version
Enable CAT tables Enter the desired number in the LCN number field to
In the service list area you determine the numerical output order of the digital
services on the television or set-top box of the end-user.
Enable HD LCN
LCN number and
HD LCN Number
All outputs will have all EIT information available, so
all actual present/following, actual schedule, other
present/following and other schedule EIT are sent
out with all muxes.
All outputs will have actual present/following and
actual schedule EIT information, but only other pre-
sent/following EIT information.
All outputs will have actual present/following and
actual schedule EIT information, and no other EIT
information.
All outputs will have actual present/following EIT in-
formation and other present/following EIT informa-
tion only.
All outputs will have actual present/following EIT
information.
No EIT information is output.
Select the Manual transportstream ID if you want to en-
able the Transportstream ID field in the Configuration
windows for output modules.
By default the Use static NIT version checkbox is dese-
lected.
Enter the desired number in the LCN number field to
the right of each service in the service list area.
the right of each service in the service list area.
Select the Enable HD LCN checkbox if you want an HD
channel to take precedence over the same channel in
SD mode.
Enter LCN numbers for both the SD and HD channels
in the fields in the service list area.
Note
You cannot give the same LCN number to
more services.
28
17-01-2014 11:25:53