Using The Analyzer; Changing The Access Level Of The Hand Held Analyzer - JLG 3394RT Service And Maintenance Manual

SECTION 5 - JLG CONTROL SYSTEM
NOTE: The cable has a four pin connector at each end; the cable
cannot be connected backwards.
2. Power up the Control System by turning the lower key to
the platform position and pulling out both emergency
stop buttons.

Using the Analyzer:

With the machine power on and the analyzer connected prop-
erly, the analyzer will display the following:
M ENU:
HELP:PRESS ENTER
HELP:
PRESS ENTER
At this point, using the RIGHT and LEFT arrow keys, you can
move between the top level menu items. To select a displayed
menu item, press ENTER. To cancel a selected menu item,
press ESC; then you will be able to scroll using the right and
left arrow keys to select a different menu item.
The top level menus are as follows:
HELP
DIAGNOSTICS
ACCESS LEVEL
PERSONALITIES
MACHINE SETUP
ACTIVATE TESTS
CALIBRATION
If you press ENTER, at the HELP:PRESS ENTER display, and a
fault is present during power up, the analyzer display will scroll
the fault across the screen. If there was no fault detected dur-
5-2
ing power up, the display will read:
HELP: EVERYTHING OK,
In ground mode, GROUND MODE OK
If ENTER is pressed again, the display moves to the following
display:
hel p:
LOGGED HELP
1: STARTUP (2/1): (Or last recorded fault)
At this point, the analyzer will display the current fault, if any
are present. You may scroll through the fault logs to view what
the last fifteen faults were. Use the right and left arrow keys to
scroll through the fault logs. To return to the beginning, press
ESC two times.
When a top level menu is selected, a new set of menu items
may be offered; If for example you choose Personalities:
DRIVE
LIFT
STEER
GROUND
Pressing ENTER with any of the above displayed menus will
display additional sub-menus within the selected menu. In
some cases the next level is the parameter or information to
be changed. Refer to the flow chart for what menus are avail-
able within the top level menus. You may only view the per-
sonality settings for selected menus while in access level 2.
Remember, you may always cancel a selected menu item by
pressing the ESC key.
Changing the Access Level of the Hand Held
Analyzer:
– JLG Lift–
In platform mode,
1: st ar t up ( 2/ 1)
3121642