Disassembly; Wedge Lock - JLG 3394RT Service And Maintenance Manual

Disassembly

5. Insert a 4.8 mm (3/16") wide screwdriver blade between
the mating seal and one of the red wedge lock tabs.
NOTE: The wedge lock should never be removed from the housing
for insertion or removal of the contacts.

Wedge Lock

The wedge lock has slotted openings in the forward, or mating
end. These slots accommodate circuit testing in the field, by
using a flat probe such as a pocket knife. DO NOT use a sharp
point such as an ice pick.
3121642
SECTION 6 - GENERAL ELECTRICAL INFORMATION & SCHEMATICS
6.
7.
Figure 6-10. Connector Disassembly
– JLG Lift –
Pry open the wedge lock to the open position.
While rotating the wire back and forth over a half turn
(1/4 turn in each direction), gently pull the wire until the
contact is removed.
6-7