Table of Contents
Advertisement
Stretch the belt until the bevels are juxtaposed.
Clean both sides of the bevels with alcohol.
Spray glue on both sides of the bevels (Glue expiration date: 1 month after opening. We advise
you to write the opening date on the glue bottle. Do not keep it later than one month after this
date).
Place the thermic press correctly aligned with the belt.
Fasten the belt on the press.
Use 2 belt pieces to align perfectly the 2 bevels.
Close the press and let warm up for 35 minutes at 120°C (250°F).
I02-121 User manual & maintenance guide
Version 02
(translation of the original manual)
of TLM 2000
Page 25 sur 41
Advertisement
Table of Contents
Need help?
Do you have a question about the TLM 2000 and is the answer not in the manual?