Emerson Rosemount 3101 Reference Manual page 52

Section 4: Starting up
February 2015
Contents (volume) measurement
Lin
H.CYL.F
SPH.
H.CYL.D
Note

To change the contents profile
1.
2.
3.
4.
5.
6.
7.
Note
If the saved profile is "Lin", the next menu option offered is "SCALE"
(see the section
If another contents profile is saved, the next menu offered is "Cont @ max"
(see the section
40
Linear (factory default setting)
Horizontal cylinder on its side with flat ends
Spherical vessel
Horizontal cylinder on its side with dished ends
This menu option is in the programming menu. See
the menu structure and how to access the menu options.
If entering the menu system from the PV display, press the green button
until the "ProF" menu option is indicated (see above note).

Press the blue button to enter the "ProF" menu and display the present profile
selection.
If the selected profile is correct, press the red button
get to the next menu option. Otherwise, continue with step (4).

Press the blue button to start the editing mode. The selected profile flashes to
indicate it can now be edited.

Press the green button

Press the blue button to confirm the new profile. (The flashing stops).

Press the red button to save if the new profile is correct, or press the blue button
not save. Afterwards, depending on the button pressed, either the "ProF" menu or the
next menu appears.
"Setting the scaling factor (on the 3102/3105)" on page
"Maximum contents (volume) entry (on the 3102/3105)" on page
repeatedly to scroll through the list of profiles (see above).
Reference Manual
00809-0100-4840, Rev CB
Figure C-2 on page 103 for a map of

repeatedly

and then the green button
44).
47).

to

to
Starting up