Assemble The Wire Contacts - Allen-Bradley MicroLogix 1762-IQ32T Installation Instructions Manual

Assemble the Wire Contacts

1. Strip the wire insulation to expose 4 mm (5/32 in.) of wire. Crimp pins can accept
22...26 AWG wire.
ATTENTION Be careful when stripping wires. Wire fragments that fall into the module could
cause damage. Once wiring is complete, be sure the module is free of all metal
fragments before removing the protective debris strip. Failure to remove the
strip before operating can cause overheating.
2. Insert the wire into the crimp pin as far as the wire stop.
4 mm
(5/32 in.)
3. Crimp the wire barrel around the wire using small needle nose pliers.
4. Crimp the insulation barrel around the wire insulation using small needle nose pliers.
Insulation barrel
5. Solder wire and wire barrel together using lead-free solder and soldering pencil.
6. Insert the assembled wire contact into the terminal socket. Push the wire contact in until
the tang latches. Make sure the tang is properly latched by lightly pulling on the wire.
Wire contact
Stripped wire
Wire stop
Tang
Wire barrel
Stripped wire
Tang
Terminal sockets
MicroLogix 1762-IQ32T DC Input Module
44916
44921
Terminal connector
44922
Publication 1762-IN019B-EN-P - June 2013
15