Allen-Bradley MicroLogix 1762-IQ32T Installation Instructions Manual page 10

10 MicroLogix 1762-IQ32T DC Input Module
Panel Mounting
Use the dimensional template shown below to mount the module. The preferred mounting
method is to use two M4 (#8) panhead screws per module. M3.5 (#6) panhead screws may also
be used, but a washer may be needed to ensure a good mechanical contact. Mounting screws are
required on every module.
For more than two I/O modules: measure (number of modules - 1) x 40 mm (1.59 in.)
100.06
(3.939)
NOTE: All dimensions are in mm (in.). Hole spacing tolerance: ±0.4 mm (0.016 in.).
System Assembly
The expansion I/O module is attached to the controller or another I/O module by means of a
flat ribbon cable after mounting as shown below.
1762 expansion
bus connector
cover
Use the pull loop on the connector to disconnect modules. Do not pull on the
TIP
ribbon cable.
Publication 1762-IN019B-EN-P - June 2013
MicroLogix
90
(3.54)
1100/1200/1400
95 (3.74)
40.4
14.2
(1.59)
(0.568)
40.4
(1.59)
Bus connector covers
44914
44569