Appendix B - User Defined Menu - Newtec AZ430 User Manual

Appendix B – User Defined Menu
APPENDIX B – USER DEFINED MENU
You can configure the user menu according to your needs. In this way, you can
create a quick access to those control, monitor and testing parameters that you
need to change or monitor regularly. In addition, you can also change the order in
which the menu items are presented to meet your specific demands. This is very
useful in, for example, the DSNG applications. Here you can pre-configure the
general parameters and store them in the default boot-configuration. You can then
make all relevant parameters that need a quick change during link setup available
as a group in the user menu. When you have done this, you can operate the WAN
Satellite Modem without having to go through all the different menus. A typical
example would be to group the parameters output frequency, output level and
transmit while leaving all other parameters untouched.
Define the user menu
Choose AZ430 > Unit > Setup > User menu and click OK.
AZ430/Unit/Setup
User menu: <press OK, ESC when done>
Choose AZ430 > Unit > Setup > User menu and click OK. This brings up the
first item from the AZ430 > Control menu:
AZ430/Control
<example parameter>
Click OK to add this menu to the list of menu items that is visible in the user
menu or press the 'right arrow' key to move to the next menu item in the control,
monitor and test menu. The available list contains all the menu items when the
device is in "expert mode".
Click OK to change the display to:
AZ430/Control
<example parameter>
The above indicates that this menu item is present in the user menu. To remove it,
click OK again.
version 1.0
32
not present
present
After a "reset to factory defaults" the user menu contents are lost.
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
User Manual for AZ430 WAN Satellite Modem
<OK> to add
<OK> to remove