Electromagnetic Compatibility; Table 3-3 Frc Parameters For Reference Sensitivity And In-Channel Selectivity - Zte ZXSDR R8882 L268 User Manual

Table 3-3 FRC Parameters for Reference Sensitivity and In-channel Selectivity

Allocated resource blocks
DFT-OFDM Symbols per sub-frame
Modulation
Code rate
Payload size (bits)
Transport block
Code block CRC size (bits)
Number of code blocks
Coded block size including 12–bits trellis termination (bits)
Total number of bits per sub-frame
Total symbols per sub-frame

3.8 Electromagnetic Compatibility

The decision rule used in this section is describes as follows:
1. Rule A
l
A communication channel is set up for the test, and it is always available during
the test.
l
FER of the forward channel and reverse channel are less than or equal to 1 during
the test.
l When the test task accomplished, equipment under test (EUT) works normally
under pre-scheduled method, there is no information loss of user control function
and the saved data, and the communication channel is still available.
l
If the EUT is a transmitter only, test should be done under idle-mode, and there
is no unintentional radiation during the test.
2. Rule B
l
A communication channel is set up for the test, and it is always available during
test.
l
EUT works normally under pre-scheduled method, there is no information loss of
user control function and the saved data, and the communication channel is still
available.
l
If the EUT is a transmitter only, test should be done under idle-mode, and there
is no unintentional radiation during the test.
3. Rule R
There is no device damage or interference (such as software malfunction or protection
device mis-operation) during the test. The EUT works normally under the defined
boundary after transient electromagnetic incident.
SJ-20110104194923-001|2011-01-19(R1.0)
Reference channel
CRC (bits)
Chapter 3 Prouduct Technical Indices
3-3
ZTE Proprietary and Confidential
A1-3
25
12
QPSK
1/3
2216
24
0
1
6732
7200
3600