......18 Your Z723EL Wireless Home Phone Base Station lets you make calls with FCC Compliance ........18 your wireless service provider’s cellular network.
Page 4
GETTING STARTED Back View Bottom View Back Cover Power Power Socket Switch Telephone Ports Note: Your Z723EL comes with an installed nano-SIM card.
Charge Your Battery 1. With the back cover facing upright, sandwich the device between your 1. Connect the adapter to the power socket on the Z723EL. Do not force the hands. Slide your top hand down to remove the back cover.
GETTING STARTED Status Indicators The indicator lights show the device’s status. INDICATOR STATUS DESCRIPTION INDICATOR STATUS DESCRIPTION Green Solid High (battery in use) Green Solid Green Blinking High (charging) Green Blinking Shutting down Power Yellow Solid Medium (battery in use) No Light Yellow Blinking Medium (charging)
• To power on your Z723EL, slide the Power Switch to the On position. of your home’s phone jacks. Position your Z723EL in a location that has a strong signal, typically near a • To power off, slide the Power Switch to the Off position. window or outside wall.
1. Pick up the handset of the connected home phone. Manage Your Voicemail 2. Dial the phone number. Your Z723EL can divert calls to voicemail, so callers can leave voicemail 3. Wait 4 to 8 seconds for the call to be connected automatically. messages when they cannot reach you.
USING YOUR Z723EL Set Up a Conference Call Notes: If your phone does not have a Flash (or Talk) key, use the off-hook mechanism When the call waiting and three-way call features are available, you can switch supported by your phone instead.
USING YOUR Z723EL Use TTY Mode Use Advanced Settings Your Z723EL is compatible with TTY devices. A TTY device can allow people COMMAND DESCRIPTION who have hearing or speech disabilities to communicate by telephone. To set the TTY mode or turn TTY support off, dial *983*889*n# on your *983*3284# Reset your device to factory settings.
DEVICE PROBLEM SUGGESTED SOLUTION Model Z723EL After turning the Z723EL on, wait 1 to 2 minutes before making a call. Dimension 1.11 x 6.30 x 5.51 in. There is no dial tone. Move the device to a location with better Weight Approximately 13.5 oz.
The FCC grant can be found under the Display Grant section of http://www.fcc. manufacturer could void the user’s authority to operate the equipment. gov/oet/fccid after searching on FCC ID: SRQ-Z723EL. NOTE: This equipment has been tested and found to comply with the limits CTIA Requirements for a Class B digital device, pursuant to part 15 of the FCC Rules.
Do not immerse the Z723EL in any liquid. The device shall only be connected to CTIA certified adapters, products • Do not place objects on top of the Z723EL. This may lead to overheating of that bear the USB-IF logo or products that have completed the USB-IF the device.
This warranty does not apply to defects or errors in the Product caused by: • Use an antistatic cloth to clean the Z723EL. Do not use chemical or abrasive cleanser as these could damage the plastic case. Turn off your Z723EL before i.
WARRANTY Limitation of Liability ZTE shall not be liable for any loss of profits or indirect, special, incidental, or consequential damages resulting from or arising out of or in connection with use of this product, whether or not ZTE had been advised, knew, or should have...