TROUBLESHOOTING
PROGRAMMING
07610-004-29-29-D
To access programming, the machine should be on and not in cycle
The programming buttons (Up-arrow, Down-arrow, and Select) are hidden on the
display and are shown below outlined with red dots There is a full-size display
template at the end of the manual to help locate the programming buttons
User Setup
1. Press and hold the Up-arrow and Down-arrow Buttons until "Setup" starts
flashing (2 - 3 seconds).
2. The display will then change to "Version" and show the firmware versions of the
IO module and PCB, Digital Display.
3. Use the Up-arrow Button to cycle through the categories (will be flashing).
•
Language
•
Temperature Scale
•
Wash Temperature
•
Boost Temperature
4. Press the Select Button to choose the category you want to change.
•
Regardless of the category, Steps 5 - 7 remain the same.
5. Use the Up-arrow Button to change the options (will be flashing). Numerical
options are shown in the top window.
6. Press the Select Button to accept the changes.
7. Press the Delime Button to exit.
PROGRAMMING
S E T U P
•
Wash Offset
•
Rinse Offset
•
Boost Offset
•
Spare Offset
L A N G U A G E
L A N G U A G E
E N G L I S H
21