Jackson Dynatemp Series Installation, Operation And Service Manual page 19

OPERATING INSTRUCTIONS
OPERATION
PREPARATION Before operating the machine, verify the following:
1. The pan strainers and suction strainer are in place and are clean.
2. The standpipe and o-ring are installed.
3. The wash and rinse arms are screwed securely into place and the end-caps are
tight. The wash and rinse arms should rotate freely.
POWER UP To energize the machine, turn on the power at the service breaker. The voltage should
have been previously verified as being correct. If not, the voltage will have to be
verified.
Press the Power Button and the display will come on. The machine will fill with water
FILLING THE
automatically until the appropriate water level is reached (just below the pan strainers).
WASH TUB
The wash tub must be completely filled before operating the wash pump to prevent
damage to components.
Power Button
12
07610-004-29-29-D