u-blox LARA-R2 series System Integration Manual page 137

This feature allows the measurement of the transmitter and receiver power levels to check component assembly
related to the module antenna interface and to check other device interfaces from which depends the RF
performance.
To avoid module damage during transmitter test, a proper antenna according to module
specifications or a 50  termination must be connected to ANT1 port.
To avoid module damage during receiver test the maximum power level received at ANT1 and
ANT2 ports must meet module specifications.
The AT+UTEST command sets the module to emit RF power ignoring cellular signaling protocol. This
emission can generate interference that can be prohibited by law in some countries. The use of this
feature is intended for testing purpose in controlled environments by qualified user and must not be used
during the normal module operation. Follow instructions suggested in u-blox documentation. u-blox
assumes no responsibilities for the inappropriate use of this feature.
Figure 70 illustrates a typical test setup for such RF functional test.
Application
Processor
AT
commands
Application Board
Application
Processor
AT
commands
Application Board
Figure 70: Setup with spectrum analyzer or power meter and signal generator for radiated measurements
UBX-16010573 - R02
Cellular
antenna
LARA-R2 series
ANT1
Cellular
antennas
LARA-R2 series
ANT1
ANT2
Objective Specification
LARA-R2 series - System Integration Manual
Wideband
antenna
Spectrum
Analyzer
IN
TX
Wideband
antenna
OUT
RX
Generator
or
Power
Meter
Signal
Product testing
Page 137 of 148