Industry Canada Notice; Declaration Of Conformity; Modifications - u-blox LARA-R2 series System Integration Manual

IMPORTANT: Manufacturers of portable applications incorporating the LARA-R2 series modules
are required to have their final product certified and apply for their own FCC Grant related to
the specific portable device. This is mandatory to meet the SAR requirements for portable
devices.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Additional Note: as per 47CFR15.105 this equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
o
Increase the separation between the equipment and receiver
o
Connect the equipment into an outlet on a circuit different from that to which the receiver
o
is connected
Consultant the dealer or an experienced radio/TV technician for help
o
4.3

Industry Canada notice

Industry Canada (IC) Certification Numbers:

u-blox LARA-R204 cellular modules:
4.3.1

Declaration of Conformity

Radiofrequency radiation exposure Information: this equipment complies with radiation
exposure limits prescribed for an uncontrolled environment for fixed and mobile use conditions.
This equipment should be installed and operated with a minimum distance of 20 cm between
the radiator and the body of the user or nearby persons. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter except as authorized
in the certification of the product.
The gain of the system antenna(s) used for the LARA-R2 series modules (i.e. the combined
transmission line, connector, cable losses and radiating element gain) must not exceed 7.6 dBi
(1700 MHz , i.e. LTE FDD-4) and 7.0 dBi (700 MHz, i.e. LTE FDD-13) for mobile and fixed or mobile
operating configurations.
4.3.2

Modifications

The IC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by u-blox could void the user's authority to operate the equipment.
Manufacturers of mobile or fixed devices incorporating the LARA-R2 series modules are
authorized to use the Industry Canada Certificates of the LARA-R2 series modules for their own
final products according to the conditions referenced in the certificates.
UBX-16010573 - R02
LARA-R2 series - System Integration Manual
8595A-1EIQN2NN
Objective Specification Approvals
Page 132 of 148