Setup Parameters - Symmetry 124 User Manual

Precision balance series analytical & toploader models
Table of Contents

Advertisement

LO LIM
HI LIM
[r Lf
END
Enter the data to be printed on the first line by pressing the [Up] or [Down] key to cycle
through the options. If the current information is OK then press the [Setup]/Enter key to
move to the next line.
e.g. "LInE 1", "DATE" - prints date
Select a code for one of the pre-set data formats as detailed above.
The next line shows: "LINE 2" "TIME" - prints time
Only one item can be entered per line.
Continue until the formatting of the form is complete. There are 15 lines of possible data.
After the 15th line has been set or "END" has been selected, the balance will return to the
RS-232 Sub-menu.
Press [Mode] to advance to setting of the next menu or press [0/T] to return to
normal weighing.
Remote Display Option
To enable the Remote Display unit, the REMOTE parameters should be set to REMOTE
ON.
The REMOTE OFF will disable the remote display.
Details of the baud rate, parity, format of the data output when REMOTE ON is selected
will be determined at a later date.
Data will be a string of characters that control the symbols on the display followed by the
weight (or other main reading from the balance such as count or density) and weighing
unit is ASCII characters.
For example
Where the characters ABCD will control which symbols are on/off on the remote display.
How many characters and what the details are will be determined as we go.

13.5 SETUP PARAMETERS

The user parameters that control the balance are shown under the setup menu. When
"SEtuP" is displayed, press the [Setup] key. The options for each parameter can be
scrolled through by using the [Up] or [Down] key.
TIME
12:23:34
DATE
Find Quality Products Online at:
© 2014
Low Limit when check weighing
High Limit when check weighing
Inserts a blank line
Signifies the end of the report
When END is entered the display returns to the RS-232 Sub-menu
ABCD ±123.4567_dwt<cr><lf>
GlobalTestSupply
www.
Set Time using the keypad numeric entry method.
Set Date using the keypad numeric entry method.
35
.com
sales@GlobalTestSupply.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

21341322022142244202 ... Show all

Table of Contents