Table of Contents
Advertisement
13.4 SETUP PARAMETERS
The user parameters that control the balance are shown under the SETUP.
When "SETUP" is displayed, press the [Setup]/Enter key. The options for
each parameter can be scrolled through by using the [Up] or [Down] key.
LANGUAGE
TIME
DATE
DATE FORM
EUROPE (dd/mm/yy)
INST ID
BUZZER
BACKLIGHT
POWER DOWN
FILTER
STABILITY
AUTO ZERO
USA (mm/dd/yy)
English
French
German
Spanish
Set Time using the numeric entry
method (see section 7.1)
Set Date using the numeric entry
method (see section 7.1)
Enter a user number to identify this
balance
On= Enable
OFF= Disable
On
OFF
AUTO
Set the time after which the unit will go
into
Stand-by
On=Enable, OFF=Disable, If set to On-
the options are 1 to 9 minutes
Set a value for the amount of filtering to
be done, set a
40 or 50. A larger number is more
filtering and a slower response. Default
is 20
Set a value to be used to determine
balance stability, set a value of 1, 2, 5
or 10d. A larger number corresponds to
a larger stable zone. Default is 5
Can be set to On or OFF to enable the
auto-zero function. If set to On- select
from 1, 2 or 5d
P.N. 8190, Revision A1, September 2006
Page 23 of 32
power
settings,
value of 5, 10, 20, 30,
Advertisement
Table of Contents
