Parameters - Symmetry EC Series Operator's Manual

• To view the totals in memory press the [Print] key when the
balance is at zero. The display will show "ACC xx" (where "xx"
is the total number of readings) and the total weight, before
returning to zero.
• The total will also be printed via the RS-232 interface.
•
To clear the memory, press [PCS] immediately after pressing
[Print].

PARAMETERS

• The balance has 5 parameters that can be chosen by the
user to set the scale.
• To set the parameters press the [Unit] key during self-
checking test.
• After a few seconds, the display will show the first function
"F1 UNT".
The following parameters are available:
FUNCTION DESCRIPTION
F1 UNT
Sets the units to be used (See section 5.1)
g ct / Lb / OZ / d / GN / OZt / dWt / MM / TL.T / TL.C /
/
TL.t /t / N /g2.
F2 EL
Sets the backlight (See section 5.2)
EL on
EL AU
EL oFF
F3 SEr
Sets the print parameters (See section 5.3)
F4 oFF
Sets the auto switch-off parameter (See section 5.4)
tECH
Pressing [Zero] will allow the user to enter the technical
parameters setting mode. It is recommended not to
proceed with the settings of these parameters as those
are set up at the factory.
: backlight always on
: backlight automatically turns on when a key is
pressed
: backlight always off
Page 10