Passcodes - Symmetry 124 User Manual

ENABLE
En on
En off
CAL REPORT
Cr on
Cr off
TIME CAL
Tic on
Tic 4
Tic off
TEMP CAL
Tpc on
Tpc 1.5
Tpc off
Press [Mode] to advance to setting of the next menu which is "PASSC" or [0/T] to
return to normal weighing.

13.7 PASSCODES

To enable the security features in this balance it is necessary to set passcodes. There are
2 passcodes called Operator Passcode and Supervisor Passcode. The Operator
Passcode allows an authorised user to operate the basic weighing functions of the balance
but will not allow access to the Supervisor Menus if the Supervisor Passcode has been
set.
To change or disable a Passcode it will be necessary to enter the current passcode.
Press [Setup] when "PASSC" is displayed to enter this section.
PC OPER
------
Pc SUPE
------
Forgotten Passcodes
Keep a record of the passcode to ensure you can access this section again. If however
you have forgotten your passcode you can still gain access by entering a universal code.
If you have forgotten the current passcode a code of "15" will always allow you to enter the
Supervisor area.
Using the Supervisor menus go to PASSCODE section. Reset the operator or Supervisor
passcode using the "15" code as the old number when asked.
Find Quality Products Online at:
© 2014
NO =operator calibration is disabled
YES=operator calibration is enabled
On = Enabled. Prints out Calibration report after
successful calibration
OFF = Disabled
On = Enabled. Select time from 1 to 24 hours.
Default setting is 4 hours
OFF = Disabled
On = Enabled. If set to On, set the temperature
variation from 0.2 to 4°C
OFF = Disabled
Enter the current passcode (OLD) first then enter a new passcode if
desired. A passcode set to zero will disable the security feature
and allow unlimited access.
First enter the current passcode (OLD) and then enter a new
passcode if desired. A passcode set to zero will disable the
security feature and allow unlimited access.
GlobalTestSupply
www. .com
37
sales@GlobalTestSupply.com