10 OPERATIONS
10.1 INITIALISATION
If an operator passcode has been set, the display will show "PC - - - - ". In this case you
must enter the passcode to continue using the numeric entry method (see section 7.1). A
different passcode may be set for a Supervisor to weigh or to have access to the selected
User menus. If the passcode has not been set the balance will continue as below.
10.2 PASSCODES
If a passcode has been set to limit access to the weighing functions of the balance the
display will show "PC - - - -". Use the numeric entry method (see section 8.1) to enter the
code. The display show the digits entered as they are set. The active digit will have the "-"
flashing. Make sure to enter the correct passcode to continue. See the Section 13.6 for
details.
Find Quality Products Online at:
© 2014
When the balance is first switched on, it will
display the balance serial number (if set),
software revision, the model capacity and then
all segments on the display will be shown.
Overall the time taken is usually 5 -10
seconds.
The display will show zero reading along with
the zero symbol "0" and the weighing unit
last used. If automatic time calibration is
enabled the balance will calibrate 15 minutes
after power up or again after the pre-set time
interval.
GlobalTestSupply
www.
19
.com
sales@GlobalTestSupply.com