Table of Contents
Advertisement
FORM
EUROPE
01:03:14(dd/mm/yy)
USA
03:01:14(mm/dd/yy)
INST ID
123456
BUZZER
Bu on
Bu Off
BACKLT
Bl 2
POWER
Pw off
Pw on
Pwon 5
FILTER
Fl 5
STABILE
stab 5
AUTO ZERO
Az 1
Dec pt
Dp pnt
The sub-menu is entered by pressing [Setup] –
Use the [Up] and [Down] keys to increase or decrease the value for setting. Press
[Setup] to accept the setting and advance to the next item in the menu
Press [Mode] to advance to setting of the next parameter or [0/T] to return to normal
weighing
13.6 CALIBRATION SETUP
This menu allows the user to set the calibration parameters.
Press [Setup] when "CAL SET" is displayed to select the calibration parameters
The options for each parameter can be scrolled through by using the [Up] or [Down] key
Find Quality Products Online at:
© 2014
Enter a user number to identify this balance
On= Enable
OFF= Disable
Set level from 0 to 5. 0=Off, 5 = on maximum
brightness.
Always on unless balance is not used for 5(?)
minutes, then turns off automatically until key is
pressed or weight >20d is detected.
Default brightness is 2
Set the time after which the unit will go into Stand-by
power settings, On=Enable, OFF=Disable, If set to
On-
the options are 1 to 9 minutes
Set a value for the amount of filtering to be done
ranging from 1 to 10. A larger number means more
filtering and a slower response.
Set a value to be used to determine balance
stability, set a value of 1, 2, 5 or 10d. A larger
number corresponds to a larger stable zone. Default
is 5
Can be set to On or OFF to enable the auto-zero
function. If set to On- select from 1, 2 or 5d
Set decimal point on the display to be a point or a
comma. Also on the serial interface. Show text and
set decimal points on the LCD to show the selection.
GlobalTestSupply
www.
36
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
