SUPERVISOR MENUS
13
Pressing the [Setup] key while in normal weighing gives access to the menus.
When [Setup] is pressed and the Supervisor Passcode is not enabled the display will
show the Supervisor menus. If passcode is enabled, the balance will ask for it by
displaying "PC - - - - "
If a wrong code is entered an "Err PC" message will flash and the balance will return to
weighing mode
If the passcode has been enabled and entered, the balance will allow the operator to
access the Supervisor's menus by which the user can enable/disable weighing units or
modes, set balance parameters for the conditions, set time and date, set parameters for
the RS-232 interface, calibration parameters and security parameters
The display will show the first menu item "UnitS". The [Up] and [Down] keys will cycle
through the main menu items, pressing the [Setup] key will enter the sub-menu or options
can be set. Press [Mode] to come out of a sub-menu or [0/T] to return to normal
weighing
13.1 ENABLE WEIGHING UNITS
When "UnitS" is displayed, press [Setup]. The display will show the symbol for the first
unit, e.g. carats, ct, together with its enable state "OFF" or "On". The user can then enable
or disable the carats unit by using [Up] or [Down]. Pressing [Setup] will confirm the
setting and will advance to the next weighing unit. Repeat for each weighing unit in turn.
Gram is always enabled
Press [Mode] to advance to setting of the next menu or press [0/T] to return to
normal weighing
13.2 ENABLE WEIGHING MODES
The same steps are followed to enable or disable the weighing modes:
Press [Setup] when "MOdES" is displayed. The display will show the first mode i.e., Parts
Counting ("Parts") together with its enabled state "OFF" or "On". The user can enable or
disable the parts counting mode by using [Up] or [Down]. Pressing [Setup] will confirm
the setting and will advance to the next weighing mode. Repeat for each mode in turn
Press [Mode] to advance to setting of the next menu, or press [0/T] to return to
normal weighing
13.3 ENABLE SERIAL INTERFACE PARAMETERS
GlobalTestSupply
www.
.com
Find Quality Products Online at:
sales@GlobalTestSupply.com
33
© 2014