Table of Contents
Advertisement
This product has been manufactured in accordance with the harmonised European standards,
2004/108/EC, Electro Magnetic Compatibility
Directive
2006/95/EC, Low Voltage Directive
2011/65/EC, RoHS, on the Restriction of the
use of certain hazardous substances in
electrical and electronic equipment
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. The
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
Shielded interconnect cables must be employed with this equipment to insure compliance with the
Changes or modifications not expressly approved by the manufacturer could void the user's authority
Any Electrical or Electronic Equipment (EEE) component or assembly of parts intended to be
incorporated into EEE devices as defined by European Directive 2012/19/EU must be recycled or
disposed of using techniques that do not introduce hazardous substances harmful to our health or the
environment as listed in Directive 2011/65/EC or amending legislation.
Battery disposal must be performed according to local laws and restrictions.
Find Quality Products Online at:
© 2014
Manufacturer's Declaration of Conformity
following the provisions of the below stated directives:
FCC COMPLIANCE
the user will be required to correct the interference at his own expense.
pertinent RF emission limits governing this device.
to operate the equipment.
WEEE COMPLIANCE
GlobalTestSupply
www.
Standard EN61326-1:2013, Electrical
Equipment for Measurement, Control and
Laboratory Use – EMC requirements – Part 1:
general requirements.
Standard EN61010-1:2010, Safety
requirements for measurement, control and
laboratory use equipment
– Part 1: General requirements.
Restricted substances referred to in Article 4(1)
and maximum concentration values tolerated by
weight in homogeneous materials do not
exceed prescribed limits.
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
