Operation; I Turning Power On; I Channel Selection - Icom IC-F610 Instruction Manual

2

I Turning power ON

q Push [K
] to turn the power ON.
I
• A power-up alert tone sounds for about 1 sec. and an opening
message may appear.
w If the transceiver is programmed for a start up passcode,
input digit codes as directed by your System operator.
• The keys in the diagram below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY [P0]
NUMBER 0
5
e When the "
PASSWORD
inputting 4 digits, the input code number may be incorrect.
Turn power off and start over in this case.
7
[P1] [P2] [P3] [P4]
1 2 3 4
6 7 8 9
" indication does not clear after

I Channel selection

Several types are available, and the channel selection
method may differ according to your system set up.
NON-BANK TYPE:
Push the /
[CH Up] [CH Down]
ating channel, in sequence; or,
push one of the [ ] to [
CH 1 CH 4
directly.
BANK-TYPE:
Push [ ] to select the desired bank number.
BANK
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.

OPERATION

keys to select the desired oper-
] keys to select these channels