Remove Control Panel - Maytag MDG25PN Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open dryer top (See page 4-3).
2. Remove two T-20-1/4" hex head screws
from each end of control panel.
Left Side
T-20-1/4" Hex
Head Screws
3. Lift control panel up to release two tabs
from the upper edge of the dryer.
2 Tabs

rEMOvE cOnTrOL PanEL

Right Side
4-4
4. Disconnect wire harness Rast connector
from the CCU to UIC.
5. Disconnect key pad ribbon connector by
gently pulling it out of the connector.
6. Disconnect transformer wire connector at
AA6.
7. Disconnect service switch wire connector at
AA1 for PD models.
8. Disconnect coin 1 wire connector at AA4.
9. Disconnect coin 2 wire connector at AA5.
10. Disconnect Earth wire. Depress locking
tab and pull connector off the spade, which
is secured to the control panel with a screw.
11. Remove control panel.
Coin 2
AA5
Earth Coin 1
Wire AA4
TEcH TiP: The extra length of plastic at the
end of the ribbon connector must be bent
back over the top of the end of the ribbon
connector, not down and under or it will
block the connections preventing operation.
Transformer
CCU to
AA6
UIC
Service
Push Button
Switch
Ribbon
AA1
Connector