Maytag MDG25PN Service Manual page 14

n SErvicE accESS cODE - Pn Models
This code can be entered to access service
mode without removing the console. It
only functions on dryers set up for 0 vend
price without any Special Pricing set-up,
and the Coin/Debit Option must be set to
"J._d". If the dryer is not in failure mode,
the door must be opened to proceed.
Service Access Code contains 6 steps and
some are timed. Using the three buttons
(numbered 1, 2, and 3 from left to right):
1. Press 2 for longer than 2 seconds but less
than 10 seconds.
2. Press 1 & 3 together for 2 seconds, then
release. Displays S 3.
3. Press 1 & 2 together, then release.
Displays S 4.
4. Press 2 & 3 together, then release.
Displays S 5.
5. Press 2, then release.
Displays "codE".
6. Wait at least 2 seconds, but not more than
15 seconds, then press in succession: 3, 2,
1, 3.
nOTE: If the Service Access Code
procedure is not completed properly, as
noted above, there is a 15 second delay
before it can be attempted again.
There are 3 options to exit from the Service
Mode:
1. From Set-up Code 8, press button #1 for 4
seconds.
2. Wait 2 minutes without touching any buttons
(without diagnostic modes running).
3. Power down the dryer, then reapply power.
n Pn Models with a key switch on the
console: Insert access key and turn
counter-clockwise.
iMPOrTanT: The console must not be
opened unless power is removed from the
dryer.
To access connector aa1:
1. Unplug dryer or disconnect power.
2. Open console, disconnect plug on AA1,
close console.
3. Plug in dryer or reconnect power.
1-8