General User Information - Maytag MDG25PN Service Manual

Blank display
This condition indicates the dryer is
inoperative. Check RFI device and for correct
voltage to UIC from the transformer.
Scrolling "out of order" message in display
This condition indicates the dryer is
inoperative. Diagnostic or Failure Code
displayed after the scrolling "out of order"
message is the best indication of the reason
for the condition.
"0 Minutes" showing in display
This condition indicates the dryer cannot
be operated. Coins dropped or debit inputs
during this condition will be stored in escrow
but cannot be used until normal operation is
restored by opening and closing the door. If
a door switch fails, it must be replaced before
normal operation can be restored.
cold start (initial first use)
Dryer is programmed at the factory as follows:
n 5 minute dry time for PN models, A series.
45 minute dry time for PN models, B series.
n
n 5 minutes per quarter for PD models.
n $1.50 dry price (fixed cycle with top off - PD
models).
$0.00 dry price (fixed cycle - PN models).
n
Warm Start (after power failure)
A few seconds after power is restored, if a
cycle was in progress at the time of the power
failure, 'RESELECT CYCLE' will flash in the
display. This is to indicate the need for a fabric
setting button to be pressed to restart dryer.

GEnEraL uSEr inFOrMaTiOn

Pricing
After the door is opened following completion
of a cycle, the display indicates the cycle price
(unless set for free operation). As coins or
debit inputs arrive, the display will change to
lead the user through the initiation of a cycle.
There are four (4) types of pricing:
Fixed 'vend' Pricing
A dryer set up for 'Fixed Cycle' operation can
only accept additional time accumulated by
increments equal to the length of a complete
dry cycle. A maximum of 99 minutes may be
purchased; no additional credit is given when
99 minutes is in the display.
accumulator Pricing
If the price is set to one coin 1, then
accumulator mode is in effect. Cycle time can
be purchased one coin at a time (PD models)
up to the maximum time of 99 minutes.
Fixed cycle With Top Off Pricing
A dryer set to offer 'Top Off' capability will
allow time to be added to an existing dry
cycle in increments equal to the number of
minutes of dry time per quarter (coin 1), up to
99 minutes, regardless of the cost required
to start the dryer. No credit is given for coins
or debit inputs entered when the control is
displaying 99 minutes.
PN models converted to PR: In Enhanced
Debit Mode, the top off price can be set
independently. (See VALUE OF COIN 2), and
the top off time is calculated according to the
following equation:
top off price
full cycle price
Penny increment offset is not applied to top off
purchases.
1-5
top off time
=
full cycle length